-
- change outer dimension of RICH detector - change width and length of RICH - change mainframe - make shape in top view rectangular - make slope on front - reuse mainFrame3 - change mainframe5 to trapezoid form - add new mainframe7 which replace some of the mainFrame2 - cutoff shieldingbox - add new mainframe8 in x-direction - reduce some mainframes by a length of (2x) thickness from the mainframe to reduce overlapping - cutoff a cubic where mainframes cross each other - change the length of the pillars - Rich entrance window - change width of the entrance window - add 10cm wide and 2cm thick Aluminum flange - reduce size of entrance window without flange a bit - Rich exit window - add 10cm wide and 2cm thick Aluminum flange - change width to 569cm - change hight to 384cm - change material of exit window from kapton to Polycarbonat - increase thickness to 1cm - Add Studs to each pillar - 10cm x 10cm 0.2cm thick Aluminum - Add Connections between pillars - 6cm x 2.5cm 0.2cm thick Aluminum - Make beampipe to beampipe tunnel - change material to carbon - change radius at entrance and exit - change pipe thickness to 0.3cm - increase the length by 0.5cm - change and increase cutoff at middle mirror parts - increase hole in sensitivity plane (move subtracted Cone) - remove belt types 4 and 5 because of overlap with the beampipe tunnel - change CreateStuds - CreateStuds now need length and angle - selecting of length and angle with fix value if conditions is removed - remove some typo failurs where was schieldingbox written instead of shieldingbox. - renamed Polycarbonat to RICH_Polycarbonat in media.geo - change cutoff cone in exit, entrance window and senseplane to tubes to fix issue with a small structure hanging in the circle. - add some comments about creating older version of geometry. - make output reproduceble and change commet about producing older versions.eb21a51c
